Replacing The Power Cable - Toolson PRO-OS 280 E Manual De Instrucciones

All manuals and user guides at all-guides.com
5.3 Securing sanding/grinding paper using a
Velcro fastening (Fig. 5)
•
Only use sanding/grinding paper of the ap-
propriate size and suitable perforations.
•
Place the sanding/grinding paper on the
oscillating plate (7) as shown in Fig. 5. Make
sure that the perforations in the sanding/grin-
ding paper line up with the oscillating plate.
5.4 Securing sanding/grinding paper using a
clamp (Fig. 6)
Only use sanding/grinding paper of the appropria-
te size and suitable perforations.
•
Raise the lever (8) on the front of the orbital
sander slightly and detach it.
•
Insert the sanding/grinding paper as far as
possible into the open clamp and close the
lever again.
•
Place the sanding/grinding paper taut over
the orbital plate (7) and clamp it again using
the second lever (8) on the rear of the orbital
sander.
•
Make sure that the perforations in the san-
ding/grinding paper line up with the oscillating
plate.
6. Operation
6.1 Switching the machine on and off (Fig. 7/
Item 2)
To switch on:
Press the control switch (2).
Continuous operation:
Lock the control switch by pressing the locking
switch (4).
To switch off :
Press the control switch briefl y and release it.
6.2 Speed control (Fig. 7/Item 3)
To pre-select the speed turn the knurled screw (3)
on the switch.
Plus direction: Higher speed
Minus direction: Lower speed
Anl_PRO_OS_280_E_SPK7_Teil1.indb 15 Anl_PRO_OS_280_E_SPK7_Teil1.indb 15
GB
6.3 Working with the orbital grinder/sander
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with gent-
le pressure over the workpiece completely
circular movements or moving it to and fro
and up and down.
•
Use a coarse paper for coarse sanding and a
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Caution!
The dust generated when working with the machi-
ne may be harmful.
•
Always wear goggles and a dust mask when
carrying out sanding/grinding work.
•
Everybody who uses the machine or enters
the workplace must wear a dust mask.
•
Do not eat, drink or smoke at the workplace.
•
Do not use the machine on paints which con-
tain lead.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 15 -
26.02.14 16:13 26.02.14 16:13