Functions And Settings - Magnusson 3663602850809 Manual Del Usuario

02 To install batteries
• This instrument requires 4 x 1.5V AA batteries (not included).
• Remove the battery compartment cover.
• Insert the batteries paying attention to the polarity (+/-) marked on the compartment and batteries.
• Close the battery compartment cover.
CAUTION!
• ALWAYS turn off the instrument before replacing the batteries.
• ALWAYS remove the batteries if the instrument is not to be used for
extended periods.
• ALWAYS use high quality batteries of the same brand, type and age.
• If the instrument does not work properly, or the low battery icon is displayed,
replace the batteries immediately.
• DO NOT expose the batteries or instrument to extreme temperatures or direct
heat source, as this can cause the batteries to leak.
• If the batteries should leak, remove them using a cloth and dispose of them
according to local regulations. Clean any leaked battery acid avoiding any contact
with skin, eyes & mouth.
• If any contact does occur, rinse affected areas immediately with fresh water and
seek medical advice.

Functions and settings

01 Operation instructions
Your self-levelling cross-line laser level has two working modes.
Self-levelling mode
In this mode, the tool will level itself if it is within ±4° of horizontal.
1.
within ±4° of horizontal.
2. Turn the tool on by pressing the mode button. The self-levelling cross-line laser level will automatically level within 5 seconds.
3. Press the mode button until the desired laser-projection mode is achieved and the laser line is projected from the laser aperture.
4. If the laser level is greater than ±4°horizontal, the laser line will blink.
5. To turn the laser off, press and hold the mode button until the laser shuts off.
Lock mode
This mode cannot be used to perform horizontal or vertical levelling, because the laser lines are no longer self-balancing.
In this mode, the laser line will blink once every 3 seconds even if it is within ±4° horizontal.
1. Slide the Lock switch to the lock position.
2. Press the mode button until the desired laser-projection mode is achieved and the laser line is projected from the laser aperture.
3. To turn the laser off, press and hold the mode button until the laser shuts off.
KNG2109203_ONLINE.indd 6
6
23/06/2021 12:37