Edirol STUDIOCANVAS SD-80 Guía De Iniciación página 31

3
When "OMS is installed on this computer..." appears, click [FreeMIDI].
4
The first time the software is started up, a dialog box saying "Welcome to
FreeMIDI!" will appear. Click [Continue].
5
When the FreeMIDI Preferences dialog box appears, click [Cancel].
6
When the About Quick Setup dialog box appears, click [Cancel].
7
From the File menu, choose Open.
8
Select SD-80 from the FreeMIDI Setting folder you copied in step 1, and
click [Open].
9
Verify that MIDI transmission and reception occur correctly.
From the MIDI menu, choose Check Connections.
fig.3-13_40
10
The mouse cursor will change to the
shape of a note. Click on the icon of
each port in the diagram at right.
If you hear sound, MIDI messages are
being sent from the Macintosh to the
SD-80.
Does the SD-80's PART level meter move?
If the PART level meter in the SD-80's display is moving but you do not hear
sound, check whether the volume of the SD-80 or your speaker system has
been lowered. If the PART level meter does not move, check the connections
and OMS settings once again.
11
Once again choose the MIDI menu command Check Connections to end
the test.
12
From the File menu, choose Quit to exit FreeMIDI Setup.
This completes the series of steps needed to connect the SD-80 to the
Macintosh, install the MIDI driver, and make the driver settings. Now, MIDI
data can be input and output (recorded and played).
Installing & Setting Up the Driver (Macintosh)
Additional information
about the ports
SD-80 Port A:
Sends/receives data for
SD-80 part group A
SD-80 Port B:
Sends/receives data for
SD-80 part group B
SD-80 MIDI InOut1:
Sends/receives data from
the SD-80's MIDI IN 1/
OUT 1 connectors
SD-80 MIDI InOut2:
Sends/receives data from
the SD-80's MIDI IN 2/
OUT 2 connectors
If the SD-80 does not
produce sound, refer to
"No sound (p. 36)".
31