Edirol STUDIOCANVAS SD-80 Guía De Iniciación página 7

Rack-mount adaptor
Use this when you want to install the SD-80 in an audio rack. Two rack ears are included.
Attaching the rack-mount adaptor
fig.um550
1. Remove three screws (on each side)
from the right and left panels of the
SD-80.
2. Using the screws you removed in step
1, attach the rack-mount brackets to the
SD-80.
* You must use the screws that you removed.
Do not use any other screws.
Desk-stand mount
Use this when you want to place the SD-80 vertically. (with Cushion sets)
Attaching the desk-stand mount
fig.cushion
1. Remove three screws from the right panel of the
SD-80.
2. Affix the cushion set (stickers) to the locations shown
in the diagram at right.
3. Using the screws you removed in step 1, attach the
desk-stand mount to the SD-80.
* You must use the screws that you removed. Do not use any
other screws.
When standing the SD-80 on its side, make sure to
position it so the power switch is at the bottom.
Do not place the SD-80 on its side at the edge of
a table or high location (e.g. top of book shelves
and furniture) to avoid physical injury or
property damage.
Cushion set (stickers)
Contents of the Package
7