Publicidad
Idiomas disponibles
Idiomas disponibles
Step 2: Pass the wires through the reader cable gland. Adjust the emergent cable length to allow normal closing of the reader.
Step 3: Put the reader back on the mounting plate by sliding it down on the 4 mounting screws.
Step 4: Tighten the locking screw (with its gasket) with provided Torx T8 tool.
If you want to mount the reader with KFX-UHF, please follow the Steps 1 to 3 to remove the metal mounting plate from the reader.
Then follow the next steps:
Fix the standard 75x75 mm VESA type mounting
bracket on the reader using the M4x12 stainless
steel screws provided in the mounting kit.
J2
0
J1
J1
Use this connector for earth connection purpose
End of line resistor RS485
Use this (on RS485 connection) when the distance of the data
J4
cable is near or over 100 m / 328.08 ft and the signal is
weakened (polluted signals, frame errors etc.).
J5
TTL output level: +5V or V
J6
Micro USB connector for configuration purposes only
J11
J10
Pull Up output: +5V or V
SW1
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1149X01 - Page 3 sur 12 - Ed. 06/01/2022
SPECTRE nano
UHF & Bluetooth
reader
®
Installation procedure
Adjustable pole-mounted kit (KFX-UHF-09)
J10
IN
Buzzer
IN
Anti-intrusion switch
SPECTRE nano
Lecteur UHF & Bluetooth
®
Notice d'installation
Mounting with KFX-UHF
TTL / RS232 / RS485 Connection
J6
J4
J2
1
2
3
4
5
6
7
8
SPECTRE nano
Lector UHF y Bluetooth
Manual de instalación
Adjustable wall-mounted kit (KFX-UHF-08)
SW1
J5
J11
Type
Clock
Wiegand
& Data
GND
+Vcc
D0
DATA
D1
CLOCK
IN
IN
OUT
OUT
COM
COM
NO
NO
US
FR
®
ES
RS485 / RS232
L+ / TX
L- / RX
IN
OUT
COM
NO
Publicidad
