Pcb Jumpers And Leds: Revised Main Pcb - Mettler Toledo IND310drive Manual De Instalación

IND310drive Installation Manual
Jumpers/
Jumpers/

PCB Jumpers and LEDs: Revised Main PCB

Figure 2-14 shows the locations of jumpers and LEDs on the revised main PCB.
Figure 2-13: Revised Main PCB – Locations of Jumper W1 (left) and LEDs (right)
The revised main PCB has a single internal jumper, used to configure the COM 2
port on J16. The IND310drive terminal as delivered from the factory can be
configured five ways:
•
•
•
Jumper settings and LED indications are as follows:
Jumpers/LEDs
2-16
On Off
LEDs
LED1 X
LED1 X
LED1 X X
Table 2-11: Power Supply Board Standard Settings
On Off
LEDs
LED1 X
Single analog
Dual analog
One POWERCELL
Table 2-12: Main Printed Circuit Board
On Off
W1 X
Power on.
Power off. If unit is plugged in, check main power,
power connections, proper seating of the board, and
fuses before contacting service.
Flashing. Power is on and communication is ok.
Indicates power is being supplied to the terminal. If main
power is available to unit and LED is not on, check
power supply fuse.
Single analog and one POWERCELL
•
Two POWERCELLS
•
Description
COM 2 emulates RS-485
Description
Description
4
3
5
1