Qlima P 126 Instrucciones De Uso página 94

C
a
b
c
c
d
e g
f
4
94
OPERATION
1 Insert the plug into the wall outlet.
2 Press the -button to switch on the air conditioner.
3 With -button you can change the operating mode of the unit.
By pressing the -button the following modes appear:
Cooling, the green light lits.
Dehumidifying, the orange light lits.
Air circulation, the yellow light lits.
COOLING
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Medium setting.
Lowest setting.
• The temperature can be set by pressing the
between 16°C en 32°C. The display will show the set temperature for 15
seconds and the "set temp" will light up. Fifteen seconds after setting the
required temperature, the display will show the room temperature.
G
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperature remains above the "set temp".
DEHUMIDIFYING
When the unit is primarily used as a dehumidifier, then please follow these
instructions: Do not connect the air exhaust hose and let the warm air go
back into the room. Connect a drainage hose onto the permanent drain
connector on the back of the unit (refer to Chapter G). You must connect a
drain tube to the water outlet .
DEHUMIDIFCATION OPERATION
Press the button on the remote or the MODE button on the control panel
to select the dehumidifier mode. The fan will operate on low speed.
The dehumidifier indicator light will illuminate and stay solid while the
unit is dehumidifying. When the humidity in the room is 50% or lower, the
compressor will not run, the unit will not dehumidify, and the dehumidifier
light will blink.
When the unit is in the dehumidifying mode, the fan speed cannot be
adjusted when the temperature is below 25ºC. The fan speed will be
-button
and buttons, anywhere