System Overview - Phonic JUBI 12A DSP Manual De Usuario

1
2
3
4
6
9
2
5
7
8
10

SYSTEM OVERVIEW

1. DSP Display
This screen will display the functions of the internal DSP.
Use the DSP MENU control to adjust these functions.
2. DSP MENU Control
This control is used to control the digital signal processor.
Turn to the left or right to scroll through menus and adjust
parameters. Push the button in to select the parameter
you wish to adjust and again to confirm. Push and hold
the button to return to the main menu.
3. Mic/Line Gain Controls
These controls allows you to adjust the incoming signals
from the Mic/Line Combo input jacks. Setting them to the
left-most position (-∞ dB) will completely cut the incom-
ing signal, whereas the right-most position (MAX) will add
10dB of boost to the signal. Each input also has a volume
control available within the DSP software.
4. Combo (XLR / ¼") Input Jacks
These inputs are design to accept mic and line level sig-
nals through these combination jacks. They accept either
XLR or ¼" phone jacks (balanced or unbalanced). The
level of this input's signal is affected by the corresponding
mic/line gain control.
5. AUX In
This 1/8" mini-stereo jack is for connection of auxiliary
devices to the Jubi DSP. This may include a CD or MP3
player through use of a mini-stereo connector or y-cable.
The volume of this input can be adjusted through the Jubi
DSP's software.
6. Link/Mix Output
The XLR line output will send the Jubi's main mix, allow-
ing the signals to be employed by additional speakers or
other devices. Do not under any circumstances connect
this output connector to the input of the same unit. This
will cause an audio loop at frequencies and levels that will
be extremely unpleasant.
This output can be used in conjunction with subwoofers
by simply utilizing the subwoofer low-pass filter function
activated within the software.
7. Master Volume
This rotary control will adjust the final output level of the
Jubi DSP loudspeaker. The Jubi DSP also features an
AMP out volume control within the DSP software.
8. Bluetooth Link Indicator
This LED indicator will light up whenever a connection
is established between another Bluetooth device and the
Jubi. The Jubi DSP's Bluetooth can be found on your
phone or tablet as "Phonic.BT" and the password is 0000.
When Bluetooth is unpaired, the word "unpaired" will
appear on screen beside the BT name.
9. AC Power Connector
Connect the included AC power cable to this connector
and into a suitable power source allowing the unit to be
powered. This connector also contains the Jubi's fuse. If
the fuse blows, please replace it with an identical fuse as
listed directly above the AC connector.
10. Power Switch
This switch will turn the Jubi DSP speaker on and off.
JUBI 12A DSP / JUBI 15A DSP