Eldom boni Instrucciones De Uso página 11

CAUTION
Be cautious when trimming hair in sensitive spots, such as face, stomach, etc.
• Trim small areas, slowly passing the appliance along the natural direction of the coat.
CAUTION
Do no use the hair clipper for wet hair.
The head (A) becomes hot when in operation, which is natural. Switch off the appliance (1)
from time to time, using the switch (C), and check whether the head (A) is not too hot. If this is
the case, stop trimming and wait for the head (A) to cool down.
• With loud operation of the appliance, adjust the head with the regulator (D).
• After the work, switch off the device with the button (C) pushed downwards and disconnect the
power cord from the mains.
Comb
The comb (3) is intended for both preliminary combing out of the coat (with the wide-spaced teeth)
and more precise styling (the other side).
Brush
The brush (6) is used to tidy the coat, remove dead hair and excess underfur. Regular brushing
prevents felting. Tangled coat should be first combed out with the comb (3).
Scissors
use the scissors (13) to trim coat, especially in the places that are hard to reach for the appliance.
Cutter
The cutter (4) is used to trim claws that cannot be word down naturally. Make sure not to trim the
claws too short.
File
use the file (14) to smoothen the claws after trimming, so that they are not prone to catching and
chipping.
CLEANING
Cleaning the head (A) of the appliance and all accessories after each use is recommended.
• Do no immerse the appliance (1) or the cord in water or in other liquids.
• Before cleaning the appliance (1), set the switch (C) in the position "0" and disconnect from the
mains, and then remove the attachment (9, 10, 11, 12)
• Clean the head (A) with the brush (5).
• Do not use cleaning agents that are strong or destructive to the surface.
• Wipe the enclosure of the appliance (1) with a damp or dry cloth.
• The attachments (9, 10, 11, 12) may be washed in warm water with washdish.
MAINTENANCE
Regular maintenance of cutting blades is necessary. Put one or two drops of oil (7) between the
blades and run the device for several seconds.
EN 11