General Information - Agilent Technologies Turbo-V 6000 Manual De Instrucciones

16 Instructions for Use

General Information

General Information

This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
people, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The Turbo-V 6000 series controllers are microprocessor-controlled,
solid-state, frequency converters with self-diagnostic and self-
protection features.
The controllers drive (within ten steps) the Turbo-V 6000 by the
pump. They incorporate all the facilities required for the automatic
operation of the Turbo-V 6000 pump series.
Remote start/stop, pump status signals, forepump start/stop,
interlock control (for pressure switch, water flow switch. etc.)
capability, are provided via auxiliary connectors. The following
paragraphs contain all the information necessary to guarantee the
safety of the operator when using the equipment. Detailed
information is supplied in the appendix "Technical Information".
194/274 Turbo-V 6000 Controller User Manual / 87-900-855-01 (F)