Glass Information; Replacing The Light Bulbs - Muskoka Sheppard Instrucciones De Montaje

may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes
standard with a 6 ft (1.8 m) long 3 wire cord, exiting out the back of the fireplace insert. Plan the
installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum
14 ga, 3 wire with grounding type plug and connector and rated not less than 1875 watts. The extension
cord shall not be more than 20 ft (6 m) in length.
Electrical outlet wiring must comply with local building codes and other applicable regulations
WARNING:
to reduce the risk of fire, electrical shock and injury to persons.
Do not use this fireplace insert if any part of it has been under water. Immediately call a
WARNING:
qualified service technician to inspect the firebox and replace any part of the electrical system which has
been under water.
service Instructions
For Your Safety
Service must be performed by qualified/authorized service personnel only.

Glass Information

Under no circumstances should this product be operated with a
1.
broken or chipped glass panel.
Do not strike or slam the glass.
2.
Do not use abrasive cleansers to clean the glass.
3.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be
done by qualified/authorized service personnel only.

replacing the Light Bulbs

This fireplace insert uses 2 clear 120 Volt, 40 Watt, E-12 socket
base light bulbs (small base, chandelier candle type bulbs). The
light bulbs are located at the bottom of the unit. You can change
the light bulbs from the front of the firebox. For convenience,
if one of the light bulbs burns out, it may be easier to replace
all of the light bulbs at the same time.
Do not exceed 40 Watts per bulb. Use of higher rated
WARNING:
light bulbs may cause overheating and result in a fire, causing property
damage, personal injury or loss of life.
Turn the firebox power "on/off" switch to the "off" position.
1.
Let the firebox insert cool if it has been operating.
2.
3. Remove three screws (from the back from each support bracket,
starting with the third screw down from the top of trim.
4. Remove the front glass panel from the firebox by gently sliding
it forward.
5. Unscrew the 2 rosebud log screws, one on the left side and
one on the right side of the log set, to be able to remove the
log rack.
6. Lift and gently remove the log rack to reveal the light bulbs.
Unscrew each light bulb and replace with a new one.
7.
Reverse steps 3-7 to re-assemble the firebox.
8.
3