H2O TEK RD-126L/D-106 Manual Del Usuario página 19

If the water tank is dirty, wash it with cold or lukewarm water. Do not use detergent, scouring
pads, chemically treated dust cloths, gasoline, benzene, thinner, or other solvents, as these
can scratch and damage the tank and cause water leakage.
When replacing the water tank, press the tank firmly into place with both hands. If the tank is
not positioned properly, the "tank Full" sensor will still be activated, and the dehumidifier will
not operate.
Continuous Drainage
1. Remove the plastic cover above the water tank
2. Insert the pipe into the hole of water outlet port
3. Insert a PVC pipe with 9.5mm (inner diameter 9.5mm), and the recommended length is
300mm; put the other side into a container, such as a bucket.
Caution:
1. Never block the water outlet or the pipe, water will flow into the water tank if it is blocked.
2. Never bend the drainage pipe and be always lower than the outlet.
3. Must close the cover when no need continuous drainage.
19