GOK 500ERAZ Instrucciones Para El Montaje Y El Funcionamiento página 26

Universal connection set (UA):
More information about Universal connection fitting type UA can be
found at www.gok.de/montagehinweise.
More information about compression fittings can be found at
www.gok.de/datenblaetter/Schneidringverschraubungen/
Data sheet - Compression fittings.
Installation position and mounting
Installation position vertical as a matter of principle,
filter cup with filter element
Do not subject filters with plastic filter cups to ambient temperatures > +60°C, i.e. do
not install them near an uninsulated heat generator part or the exhaust pipe, and do
not install them above furnace doors which will be opened.
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
10 / 16
Single conduit filter and double conduit filter with plastic filter cup
The female thread can also take the GOK universal
connection set type UA, which corresponds to a
compression joint type G acc. to EN 12514-4
Annex D.
Piping used:
Copper pipe with outer diameter 6, 8 or 10 mm, e.g.
acc. to EN 1057
The housing is made from a zinc die-cast alloy:
Do not use a conical pipe thread acc. to EN 10226-1.
Flexible pipe assembly
The following connections may be used in addition for
flexible oil lines and their pendant:
• cap nut G 3/8 with inside taper 60° pursuant to
A reinforcement ring must be used with all thin-walled pipes and with
soft pipe materials.
Brass reinforcement rings may not come into contact with aluminium
pipe. Risk of corrosion!
at the bottom
EN 12514-4 Appendix B
Part no. 13 852 51 a