Vitrifrigo SCP Manual De Instalación, Uso Y Asistencia página 10

Refrigerator switch on
When the refrigerator is switched on, but in standby mode, the thermostat's display shows alternatively
"OFF" and the inside temperature value.
To turn on the refrigerator, hold the button
display and immediately after the inside temperature value.
Once turned on, the fridge will start working, but it will take some time (also depending on external
conditions) to reach the required internal temperature.
We recommended to put milk inside the refrigerator only when the internal temperature has stabilized to
the required value.
Temperature setting
To set the desired temperature, push the button
then adjust the value using the button
press again the button
NOTE: To ensure that the milk is always maintained at temperature allowed by the HACCP, the setpoint
can be varied only within a specific values range.
NOTE: The refrigerator can operate at lower temperatures than the level obtained, by setting the
thermostat to lower setpoint values.
However, since these temperatures are out of the envisaged range for storing milk or similar liquids
for human consumption, the manufacturer advises against using the refrigerator in this way,
stressing again that the appliance is designed and made to store milk or similar liquids for human
consumption at a controlled temperature and not to chill such products from room temperature.
Level sensor functioning
The refrigerator is provided with one milk level sensor which detects the presence of milk in the container
and generates an alarm when the level falls below about 0.5 liters of milk.
The refrigerator can be provided also with two milk level sensors (optional) to be used with milk tank
with wall divider (for two milk kind).
The refrigerator needs to be connected to Schaerer coffee machine, the milk level alarm will be shown on
the coffee machine display.
NOTE: This refrigerator is designed to work with a full milk container placed inside the refrigerator. In
this way, if the refrigerator is working without the container or with a small amount of milk, the alarm will
activate.
Refrigerator switch off
To switch off the refrigerator hold the button
Seite 10 von 72
pushed for at least 3 seconds. You will see "ON" on the
(to increase) and
.
pushed for at least 3 seconds.
until you see the current set point value flashing,
(to decrease); to store the new value
022129 BA BKE SCP EN, DE, FR, ES, IT
EN