Parts List - LUND 86521217 Instrucciones De Instalación

PARTS LIST:

1 Revolution Bull Bar
1 Driver/Left Mounting Bracket
1 Passenger/Right Mounting Bracket
2 Double Bolt Plates
2 Single Bolt Plates
1 20" LED Light Bar
1 Wire Harness
Driver/Left
Mounting Bracket
Hex Bolts
EQUIPMENT NEEDED:
Safety Glasses
•
Ratchet Set
•
Pliers or Adjustable Wrench
•
IMPORTANT NOTES:
Bull Bar may interfere with parking sensors on the bumper.
•
If state law requires a front license plate, a relocation kit is available separately.
•
For cleaning, mild soap may be used to clean the Bull Bar, and aluminum polish may be used on the stainless steel
•
to polish small scratches and scuffs on the finish.
REMOVE CONTENTS FROM BOX, VERIFY ALL PARTS ARE PRESENT, & READ INSTRUCTIONS
•
CAREFULLY. NOTE: PROFESSIONAL INSTALLATION IS RECOMMENDED.
LIGHT BAR INSTALLATION:
1. Remove light bar from box and screw bolts and washers into each end.
2. Slide bolts into crossbeam brackets with the washers on the outside of the bracket, and tighten using the supplied
allen key.
6 12mm Flat Washers
6 12mm Nylon Lock Nuts
4 8mm Bolts Assembly
1 License Plate Relocation Hardware
1 License Plate Relocation Bracket Kit
Single Bolt Plates
Double Bolt Plates
Flat Washers
Page 1 of 5
I-Sheet Number 20262 Rev.B
REVOLUTION BULL BAR
2019+ CHEVY SILVERADO 1500
Passenger/Right
Mounting Bracket
Nylon Lock Nuts
01/04/19 (DP)