Connect To The Tv; Set Up A Digital Tuner With This Antenna - Philips SDV8625T/55 Manual Del Usuario

Connect to the TV

Note
•
As previously noted, the amplifier ( Power
injector + Power supply ) must be placed
in-line between the antenna and any splitter or
additional devices.
1
Connect the coaxial cable
antenna to the connector labeled ANT
on the power injector .
2
Connect the power injector
antenna input on the TV, digital set-top
box, splitter or other devices.
3
Connect the power supply plug
the power injector , and then plug the
power supply adaptor
AC receptacle.
EN
30
DFU_SDV8625T_55_Book.indb 30
•
•
Set up a digital tuner with this
antenna
You can install available channels with the digital
TV tuner. This automatic process is part of the
setup of the tuner. Ensure the antenna has
set up properly before the tuner can receive
viewable channels.
There are two ways to connect the antenna to
the TV:
•
from the
•
to the
to
into a 100-240V
Warning
The power injector and power supply are for
indoor use only.
Tip
This antenna includes a 6m roll of 3C-2V
coaxial cable. If this is not adequate for your
needs, replace the cable with a RG-6 coaxial
cable instead of adding an extension.
Connect the antenna to a digital tuner.
If the signal strength is good enough, the
channels can be memorized in the tuner
automatically .
Connect the antenna directly to the TV.
Tune to the analogue channels and find
the best antenna location. Then re-
connect the antenna to the digital tuner.
Ensure the signal strength is good enough
before you install the channels with the
tuner.
2011-6-23 14:40:48