Craftsman CMXGVAM1144036 Manual De Instrucciones página 7

4. There are three height adjustment holes in the handlebar support bracket.
Use a setting that will position the handlebars at approximately waist level
when the tines are 3-4" into the soil. To adjust the height of the handlebars
loosen the knob on the handle, pull out on the carriage screw, adjust to the
desired setting, push the carriage screw in until the square portion of the
screw locks into place and re-tighten the knob. See Figure 4.
Carriage Screw
5. Tighten all the handlebar mounting hardware securely.
Attaching Clutch Cables
1. Carefully unwrap the cable(s) from the shipping position. To attach the clutch
cable(s), feed the cable(s) up the front of the lower right handle and behind the
handle panel. See Figure 5.
Knob
Figure 4
Figure 5
ASSEMBLY
2. Pull the forward clutch cable with the black end fitting up through the bottom
hole of the cable bracket and push the cable connector up through the hole
until the groove in the connector snaps into place. See Figure 6.
Z-Connector
3. Place the Z-connector into the hole in the forward clutch bail from the outside
of the bail to the inside. See Figure 6.
4. Pull the reverse clutch cable (if equipped) with the red fitting up through
the top hole of the cable bracket and push the cable connector up through
the hole until the groove in the connector snaps into place. See Figure 7.
Z-Connector
5. Place the Z-connector into the hole in the reverse clutch handle assembly
from the inside of the handle to the outside. See Figure 7.
7
Cable Bracket
Figure 6
Cable Bracket
Figure 7