Publicidad
Idiomas disponibles
Idiomas disponibles
•
There may be some smoke or a particular smell when the device is activated for the first time. This is
normal and any smoke or smell will gradually disappear.
•
LEDs and mechanical wear are not covered by warranty.
•
Use the original packaging if the device is to be transported.
•
Keep this manual for future reference.
4.
Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5 m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5.
Use
•
Connect/disconnect the PAR56 to/from the mains to switch on/off.
6.
Cleaning and Maintenance
1.
All screws should be tightened and free of corrosion.
2.
The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections.
3.
Moving mechanic parts must not show any signs of wear and tear.
4.
The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
5.
Disconnect the device from the mains prior to maintenance activities.
6.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7.
There are no user-serviceable parts.
8.
Contact your dealer for spare parts if necessary.
7.
Technical Specifications
power supply
power consumption
number of LEDs
Fuse
dimensions
Total weight
Max. Ambient Temperature
Max. Housing Temperature
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulted from (incorrect) use of this device.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
15/09/2011
All manuals and user guides at all-guides.com
VDLLP56SB2 - VDLLP56SC2
max. 230 VAC / 50 Hz
15 W
12 x 1 W
2 A / 250 VAC
Ø 185 x 230 mm
1.65 kg
45°C
60°C
3
Rev. 01
©Velleman nv
Publicidad
