Mounting Instructions - Reggiani MORPHY Manual De Instrucciones

• Safety glasses: Must be always in perfect condition. If damaged
or cracked proceed to replace them absolutely before switching
on the fixture.

MOUNTING INSTRUCTIONS

MOUNTING OF ONE-SECTOR FIXTURES.
1) Open two holes with centre distance as shown in dwg.
fastening the plate to the wall.
N.B. For fastening fluorescent lamps with 1 sector, 13W and
18W code 6201 and 6202, turn the reflector until opening the
lamp release mechanism thus gaining access to mounting holes
of plate (Dwg.
2) Using a screw driver
from their seats (dwg. 2) but be careful not to pull them out from
the fixture body. If wedges
of those contained in the small bag (part of the kit). If the fixture
is to be made non swivelling, use stop screws
the above bag (dwg.
3) Unhook the earthing conductor from bipolar terminal
then remove the whole sector (dwg.
4) Fix the support plate
means of the accessories (washers and gaskets) in the small box
supplied with the fixture. Fixing screws
the installer and must have partially threaded shank (dwg.
5) Mount the correct lamp type, adjust the reflector and procced to
reassemble the fixture paying particular attention to match
O
notches on the body and
T1
Hence, proceed in the reverse order until final tightening of the
two optional stop screws
the latter by clicking in (dwg.
N.B.: Tightening of screws
orient the fixture, hence this operation is to come last.
MOUNTING OF TWO/THREE-SECTORS FIXTURES.
1) Proceed in the same order as mentioned above 1), 2) and 4),
but removing in this case the two/three sectors together after
having disconnected the terminal block
the components support (dwg.
2) Fix the fixture body matching notches
described and orient the first sector (if necessary) before
tightening the two optional stop screws
3) Loosen screws
having first unhooked the earthing conductor from its bipolar
terminal) and enter the optical compartment to mount the correct
lamp type.
MORPHY
bis).
lever on the wedges
are broken, replace them with one
).
on the mounting surface (dwg. ) by
O
T2
on relative wedges
O
and remove the most external sector (after
A2
7
).
are to be provided by
on the rotating base (dwg.
and ).
makes it impossible to further
(plug and socket) on
).
O O
and
T1 T2
O
(dwg.
A1
for
to loosen them
contained in
and
).
).
and fixing
as previously
).
ENGLISH