Safety Rules - Festool OF 1400 EQ Instrucciones De Servicio

Technical data
Power
Speed (no load)
Quick height adjustment
Fine height adjustment
Drive shaft connection of the spindle
Router diameter
Weight (excluding cable)
Degree of protection
The specifi ed illustrations can be found at the beginning of the operating instructions.
1 Intended use
The routers are designed for routing wood,
plastics and similar materials.
Aluminium and plasterboard can also be
processed with corresponding cutters such
as are listed in the Festool-catalogues.
The user is liable for damage and in-
jury resulting from incorrect usage!
2 Safety instructions
2.1

Safety rules

Before using the machine, read the
enclosed safety instructions and the-
se operating instructions carefully
and thoroughly.
Save all enclosed documents and pass the
machine with all these documents only.
2.2 Tool-specifi c safety rules
- Do not exceed the maximum speed speci-
fi ed on the tool and/or keep to the speed
range.
- The clamping collet should only be used to
clamp tools with a shank diameter appro-
priate for the collet.
- Check that the cutter is fi rmly fi tted and
runs freely.
- The clamping collet and union nut must
show no signs of damage.
- Cracked or distorted cutters must not be
used.
Wear suitable protection such
as ear protection, safety go-
ggles, a dust mask for work
which generates dust, and
protective gloves when wor-
king with raw materials and
when changing tools.
All manuals and user guides at all-guides.com
3
The typical values determined in accordance
with EN 60745 are:
Sound-pressure level
Sound-power level
Measuring uncertainty allowance K = 4 dB
Measured acceleration
4
Switch (1.13) serves as an On/Off switch (I
= On/0 = Off). It may be latched with the
locking knob on the side (1.12) for conti-
nuous operation. Pressing the switch again
releases the lock. See Fig. 2 for connection
and disconnection of the power cable.
5
5.1
Do not operate the tool if the electronics
are faulty as this can lead to the tool ope-
rating at excessive speeds. If the start-up
is not smooth or speed adjustment is not
possible, this indicates that the electronics
are faulty.
9
OF 1400 EBQ/OF 1400 EQ
1400 W
10000 - 22000 rpm
70 mm
8 mm
M22x1.0
max. 63 mm
4.5 kg
/ II
Noise and vibration information
Wear ear protection!
Power supply and start-up
The line voltage and frequency must
correspond with the data on the ra-
tings plate!
Machine settings
Always remove the power supply plug
from the socket before carrying out
any work on the machine.
Electronics
The OF 1400 EBQ, OF 1400 EQ fea-
tures full-wave electronics with the
following properties:
82 dB(A)
93 dB(A)
<2.7 m/s²