Diamond GR82 Manual De Instrucciones página 3

1. - Choose a dry suitable place for the grill.
a) The grill should not be installed close to inflammable or heat deformation products.
If this is not possible, the grill working-place has to be isolated with a good thermic
non-inflammable material.
b) Chose the least wet place possible to place the grill
2. - Before connecting the grill to the power supply, check if the circuit specifications are
correctly adjusted to the grill power. The electric board (power mains) should have a
30mA protection and a circuit breaker with a 3mm separation between the contacts.
A
LWAYS CONNECT THE GRILL TO A PLUG WITH AN APPROPRIATE EARTH CONNECTION
"T"
USE TYPE ADAPTERS FOR THE SINGLE PLATE MODELS
;
DOUBLE PLATE USE PREFERABLY A FIXED INSTALLATION WITH AN APPROPRIATED EARTH
CONNECTION
3. - Turn the thermostat(s) to the required temperature up to a maximum of 250ºC (482ºF).
The thermostat(s) led lights up, and turns off when the set temperature is reached.
4. - While the set is working do not touch the metallic parts once they are very hot.
5. - CAUTION
T
O CLEAN THE GRILL
NEVER USE WATER DIRECTLY ON THE MACHINE
6. - If by accident water is spilled over the grill, it should be immediately disconnected from
the power supply and it should be properly dried, before it is used again.
7. - It is possible to regulate the tension of the upper plate by turning the screw on the upper-
back part of the grill, by using the hole-key supplied with the grill.
8. – If the power cable needs to be replaced, a cable type H05RN-F 3G 1mm2 for the single
plate grills, and a cable type H07RN-F 3G 1.5mm2 for the double plate grills, must be used.
• For the United States of America and Canada, the cable should be of the type SJTO - 14
AWG PVC 105ºC.
..................................................................................................... GB – Maio.
03.
5353.000.50 c
INSTRUCTIONS MANUAL
GRILLS
,
FIRST DISCONNECT IT FROM THE POWER SUPPLY
. F
OR THE REMAINING MODELS
.
:
DO NOT
. U
SE A WET CLOTH AND
: