Spare Parts - Heiniger Xperience Traducción De Instrucciones Originales

Malfunction
Shearing machine cuts
badly or not at all.
Motor unit becomes hot.
8

Spare parts

See spare parts list at the end of these operating instructions.
CAUTION!
FAULTY SPARE PARTS MAY CAUSE DAMAGES, MALFUNCTIONS
OR TOTAL LOSS AND MAY REDUCE SECURITY.
Use only original spare parts from the manufacturer. Obtain
X
spare parts from an authorised dealer or directly from the
manufacturer.
NOTE!
If non-approved parts are used, all warranty, service,
X
compensation and liability claims against the manufacturer or
its employees, dealers and representatives will be forfeited.
During the warranty period the device must be opened only by personnel
authorised by the manufacturer, otherwise the warranty will be void.
Pos. No. Description
Shearing machine
1 Clipper head cattle complete
2 Tension nut cattle
3 Distance screw
4 Tension sleeve
5 PH-screw M5 x 14
6 Clipper head case
7 Pressure spring
8 Pressure plate
Translation of the original instructions / Cattle clipper Xperience
Cause
shearing blade is blunt.
Clipping blades have not
been correctly ground.
Clipping blades are not oiled. Lubricate the clipping blades
Clipping pressure too low.
Leaf springs broken.
The animal's hair is wet.
Hairs jammed between top
and bottom blades.
Too much play at the clipper
head.
Clipping blades not properly
aligned.
Air filter clogged.
Clipping pressure too high.
Bearing faulty.
Rectification
Notify customer service.
every 15 minutes.
Increase the clipping pressure as
described in chapter 6.2.
Notify customer service.
Only clip dry hair.
Remove the clipping blades;
clean, lubricate and install them
again; set the clipping pressure.
Notify customer service.
Align the clipping blades
correctly, see Fig. 9.
Clean or replace the air filter.
Reduce the clipping pressure.
Notify customer service.
Quantity
1
1
1
1
2
1
1
1
17