Important Safety Instructions - Bahco TASMB Serie Traducción De Las Instrucciones Originales

TASMB AND TAWMB SERIES

IMPORTANT SAFETY INSTRUCTIONS

WARNING.
RISK OF FLYING PARTICLES.
Over-torquing can cause
calibration angle tool can
cause part or tool breakage.
or accessories can cause
slippage.
• Read this manual completely
before using ELECTRONIC
TOOL.
• To insure accuracy, work must
not move in angle mode.
• For personal safety and to
avoid tool damage, follow good
professional tool and fastener
installation practices.
• Periodic recalibration is
necessary to maintain
accuracy.
• Wear safety goggles, user and
bystanders.
• Be sure all components,
including all adaptors,
extensions, drivers and
sockets are rated to match or
exceed torque being applied.
• Observe all equipment, system
and manufacturer's warnings,
cautions and procedures when
using this tool.
• Use correct size socket for
fastener.
• Do not use sockets showing
wear or cracks.
• Replace fasteners with
rounded corners.
• To avoid damaging tool: Never
use tool with power off. Always
turn ON tool so applied torque
is being measured.
• Do not press POWER while
torque is applied or while tool
is in motion.