Bahco TASMB Serie Traducción De Las Instrucciones Originales página 7

STANDARD AND SLIM ELECTRONIC TORQUE-ANGLE BLUETOOTH
AND ELECTRONIC TORQUE-ANGLE BLUETOOTH
STD/SLIM
SCR
Target Torque Screen
LOCK icon
Note: If wrench is powered up in torque only measurement mode, angle is not zeroed until mode is
changed to angle measurement mode, at which time torque and angle zeroing begins automatically
after 2 seconds. Wrench should be placed on a stable surface with no torque applied.
Note: If screwdriver is powered up in torque only measurement mode, angle is not zeroed until
keypad is unlocked and mode is changed to angle measurement mode. The Angle Zero Required
screen will be displayed. Angle zeroing begins automatically after 2 seconds. Screwdriver should
be placed on a stable surface with no torque applied (on screwdrivers (SCR) only).
Note: Pressing ENTER button while angle is zeroing will abort zeroing function to allow user to
select another measurement mode.
TORQUE MODE
1. Set Target.
Use UP/DOWN buttons to change TORQUE target value.
2. Select Units of Measure.
Repeatedly press UNITS button while on target TORQUE screen until desired units are displayed.
®
SCREWDRIVER
TORQUE ZEROING
00
80.00
IN-LB
ENTER - UNITS - ENTER
keypad unlock sequence
00
ENTER
button
80.00
IN-LB
® WRENCH
ANGLE ZEROING
--
SET STILL
00
Target Angle Screen
180º
00
180º
IN-LB
7