Technical Data; Safety Instructions - GYS Toparc Manual De Instrucciones

Translation of the original instructions
OPERATING INSTRUCTIONS

TECHNICAL DATA

Light Source
Luminous Power
Operating time
Battery Specification
Charging Time
Charging Input
Degree of protection
Operating temperature
WARNING
• Do not open the device.
• Do not look directly into the light emitting lamp - Risk of eye injuries!
• Do not operate in direct sun light or extreme temperature conditions.
• Operating temperature, -10°C to +40°C.
• Keep away from children! Children should be supervised in order to ensure that they do not play with the device!
OPERATING & CHARGING PROCEDURE
• HEADLAMP Operating mode as below
- Press the Main Switch
- Press the Main Switch
- Press the Main Switch
- Press the Sensor switch
- Press the Motion Sensor Switch
waving your hand in front of the light (Sensor distance 0~10±3cm)
- Press the Motion Sensor Switch
- Press the Main Switch
• Switch lamp off during charging.
• The LED of the indicator switches to red during charging.
• If charging is completed, green LED illuminate will turn on.
• Always only use the charger recommended to charge the lamp.
• The use of a NON-recommended charger can lead to a fire and destroy the lamp.
• Before taking the hand lamp into service for the first time charge it for 4-5 hours.
• Fully charge the hand lamp before it is stored for a longer period.

SAFETY INSTRUCTIONS

• Do not use the device if there is damage to the housing, plug or cable. Consult your local authorized specialist!
• Do not open the device! Repair work and replacing the rechargeable battery pack may only be carried out by electri-
cians.
• Carry out cleaning tasks only when the mains plug is removed from the mains power!
• There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned and trained persons.
Please contact your nearest authorized branch.
• Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and moisture. Danger of
explosion.
4
INSPECTION HEADLAMP 280L
Keep this instruction manual for future reference or for subsequent possessors.
High power COB LED ‒ Main light
ca. 280 lumen ‒ Normal Mode Full Power
ca. 100 lumen ‒ Normal Mode ECO
ca. 280 lumen ‒ Sensor Mode
ca. 2 h ‒ Full Power Mode
ca. 5.5 h ‒ ECO Mode
ca. 2 h ‒ Sensor Mode
Li-Ion 3.7 V, 1500 mAh, 5.55 Wh
ca. 2.5 h
DC 5 V 1 A
IP 65, IK 07
-10 °C to +40 °C
first time, main light switch to ECO mode
second time, main light switch to full power mode
third time, whole light switch off
, the normal mode off, sensor mode on Sensor mode
first time, main light switch to Sensor mode, you can switch on or off by
second time, Sensor mode off and turn to normal mode
, the sensor mode off, normal mode on
EN