Publicidad
Step 21
STOP
This cabinet provides
limited security for
long guns and is not
intended for handguns,
youth guns or other
fi rearms.
PADLOCK - NOT PROVIDED
BLACK 9/16" PAN HEAD SCREW
(4 used in this step)
This hole is used for the
recommended padlock.
3-1/2"
18-1/2"
www.sauder.com/services
Place your unloaded guns in your unit so the gun stocks are sitting on the STOCK REST (K).
å
NOTE: You have the option to position your TUBE SET (85M) higher or lower in your unit.
å
Use the upper or lower set of holes depending on which option you choose.
Fasten the BAR RECEIVERS from the BAR RECEIVER/PLUG SET (92M) to the ENDS (A
å
and B). Use four BLACK 9/16" PAN HEAD SCREWS (51S).
Insert the TUBE SET (85M) into the BAR RECEIVERS (92M) on the ENDS (A and B). Then,
å
push the PLUGS (92M) into the holes in the BAR RECEIVERS.
NOTE: Refer to the diagrams below for correct placement of the hole in the TUBE SET
å
for the recommended padlock (not provided).
Once the TUBE SET is in place over your unloaded guns, lock your store purchased
å
padlock through the hole in the outer tube for additional gun safety.
Check the security of your guns once
the tube set is locked in place.
If you want to position the TUBE
SET higher, use these set of holes
51S
92M
85M
12-3/4"
WRONG
9-1/8"
B
92M
419440
A
K
Page 25
Publicidad
