Installation Space - Toshiba RAV-RM561FT-EN Instrucciones De Montaje

• In the case of the wireless type of system, rooms with the inverter type of fluorescent lighting or locations
exposed to direct sunlight.
(The signals from the wireless remote controller may not be sensed.)
• Locations where organic solvents are being used.
• The air conditioner cannot be used for liquefied carbonic acid cooling or in chemical plants.
• Location near doors or windows where the air conditioner may come into contact with high-temperature, high-
humidity outdoor air.
(Condensation may occur as a result.)
• Locations where special sprays are used frequently.
111-EN
 Installation space
Reserve sufficient space required for installation or service work.
Front side
(In case of right direction piping)
REQUIREMENT
When using the air conditioner under condition of high humidity, attach the heat insulator to the side face and the rear
side of the indoor unit.
 To open the intake grille
Grill fixing screw
Intake grill
Direction of vertical louver
Turn the vertical louver
while lifting up lightly,
and then insert it into the
clearance of extrusion of
the coupling rod.
– 56 –
500 or more 200 or
more
Front side
The intake grille is fixed by the screws for safety reasons.
Use a screwdriver to unfasten the screws of the intake
grille (two places) to open the intake grille. The screws are
designed to stay on the intake grille.
The direction of the auto turn louver (Vertical louver) may
change during transportation. As shown below, lift up the
vertical louver lightly, turn it matching with the direction of
the plastic coupling rod, insert it into clearance of the
extrusion, and then arrange the direction of the vertical
louver to the desired direction.
Vertical louver
Extrusion
Coupling rod
(Unit: mm)
112-EN