Tabla de contenido
Publicidad
TURN THE HEATER ON / OFF
TURN THE HEATER ON
1. Turn on the valve on the gas supply cylinder completely.
2. Turn the variable control knob 90 degrees counter-clockwise to Pilot
position, see picture of " " and push the igniter.
3. Press down the control knob and hold for 30 seconds. While holding
down the control knob after the pilot flame lights.
4. After the pilot flame lights, turn the variable control knob to minimum
position and leave it there for 5 minutes or more before turning the
knob to desired temperature position.
Turn the knob to "LOW" position for small flame.
See picture of "
Turn the knob to 'HI" position for big flame.
See picture of "
NOTE
• If a new tank has just been connected, please allows at least one
minute for the air in the gas pipeline to purge out through the pilot
hole.
• When lighting the pilot flame make sure that the variable control
knob is continuously pressed down while pressing the igniter button.
Variable control knob can be released after the pilot flame lights.
• Pilot flame can be watched and checked from the small round
window with sliding lid located at the bottom of the flame screen (to
the left or right side of the controller).
• If the pilot flame does not light or it goes out, REPEAT STEP 3.
TURN OFF THE HEATER
1. Press and turn the variable control knob to OFF position.
2. Turn off the valve on the gas supply cylinder completely.
STORAGE
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Remove the pressure controller and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect damage, have it changed by
your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
CLEANING AND CARE
•
Wipe off powder coated surfaces with soft, moist rag. For lacquer surface, use suitable cleaners.
Do not clean heater with cleaners that are combustible or corrosive.
Remove debris from the burner to keep it clean and safe for use.
•
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
".
".
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Control knob
Igniter
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
