Operation; Connect The Water Supply To The Machine; Use The Spray Gun; Change The Spray Tip - GreenWorks ELITE EPW2000 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Install and tighten the other end of the high pressure hose
onto the water outlet (23) coupler.
4

OPERATION

WARNING
Make sure that all the connections are tight and have no
leakage before operation.
4.1
CONNECT THE WATER SUPPLY
TO THE MACHINE
For easy operation, please use a self-coiling garden hose (not
provided).
WARNING
When you operate the self-coiling hose, make sure that the
hose has no blockage.
WARNING
The water supply must come from the water main
Do not use hot water
Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
If the filter is damaged, do not use the machine until the
filter is replaced.
If the filter is dirty, clean the filter.
22
1. Uncoil the garden hose (24).
2. Let the water flow through the garden hose (24) for 30
seconds.
English
24
9
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (24) to the
water inlet (22) connector.
CAUTION
There must be a minimum of 3 m of free hose between the
water inlet and the water supply.
4.2

USE THE SPRAY GUN

WARNING
For safe control, keep your hands on the gun at all times.
Pull and hold the spray gun trigger (25) to start the
machine.
Release the spray gun trigger (25) to stop water flow
through the spray tip (11).
4.2.1
UNLOCK THE SPRAY GUN TRIGGER
Push the trigger safety lock-out (26) down until it clicks
into the slot.
4.2.2
LOCK THE SPRAY GUN TRIGGER
Push the trigger safety lock-out (26) up and into it's
original position.
4.3

CHANGE THE SPRAY TIP

11
27
25
26
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido