Placing The Camera On The Cyber-Shot Station; Removing The Camera From The Cyber-Shot Station; Charging The Battery Pack - Sony CSS-HD2 Manual De Instrucciones

The Remote Commander range is less than

five meters (for indoor use). Point the Remote
Commander at the remote sensor of the Cyber-
shot Station. Try adjusting the angle of the
Remote Commander if you cannot operate the
Cyber-shot Station.
Placing the camera on the
Cyber-shot Station
Remove the Adaptor ring, the Conversion lens,
etc. from the camera.
Attach the camera as shown below.
Be sure to turn off the camera before placing it on

the Cyber-shot Station.
When attaching the camera, make sure to insert

the camera straight down.

Tips
Make sure that the camera is securely attached to

the Cyber-shot Station.
1-GB
Removing the camera from
the Cyber-shot Station
Hold the Cyber-shot Station down when you

remove the camera from the Cyber-shot Station.

Notes
When removing the camera, make sure to lift the

camera straight up. It may damage the camera or
the Cyber-shot Station when some extra force is
added to the front or the sides.
Charging the battery pack
Place the camera with the battery pack
inserted on the Cyber-shot Station.
Charging starts automatically. The CHARGE lamp
of the Cyber-shot Station lights up.
When the camera is turned on, the Cyber-shot

Station cannot charge the battery pack.
When the charging reaches to Normal charge*,

the CHARGE lamp goes off.
* Recording and playback time with Normal
charge is approximately 90% of Full charge.
For the time of the full charge for a completely

discharged battery at the temperature of 25 °C
(77 °F), see the table below.
DSC-T300/T75/T70/T2
DSC-
W300/W170/W150//W130/
W125/W120/W115/W110
– It may take longer to charge, depending on the
charging condition and environment.
Approx.
160 minutes
Approx.
230 minutes