Fitting High Flow Element - Watson-Marlow 505LA Manual Del Usuario

14.2 505L: Fitting high flow element
Note: When using Pumpsil 9.6mm elements, best results will be obtained from a High-flow element:
part number 913.AH96.K24. The clamp is required to secure the element on the suction side of the
pumphead.
If using a 9.6mm High-flow element:
Lift the two levers at either side of the pumphead and remove the track.
l
Remove the mushroom peg on the suction side of the pump by turning it counter- clockwise
l
through one quarter turn and withdrawing it. Do not remove the peg on the delivery side.
Lay the element across the rotor, with the smaller Y-connector over the end peg on the delivery side.
l
Tube clamps are marked with the nominal bore for their intended tubing. Pull the element taut and
l
firmly secure it with a 9.6mm clamp on the suction side of the pumphead, using the bayonet-style
fixing previously used for the mushroom peg.
Replace the track and secure it by closing the two levers.
l
Ensure the braided earth lead is securely connected to both the track and pumphead body.
l
PB0379:m-505atex-en-04 25