Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
reiNstall DraWers
ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
slide
self closiNG sliDes
The self closing feature will pull the drawer closed when
the drawer is pushed past the slide detent. This is located
approximatley 1/2" from the fully closed position.
All manuals and user guides at all-guides.com
5
removiNG aND iNstalliNG sliDes
slide removal -
• The drawers in these units can be rearranged to fit your
specific needs. This means that drawers may be moved
or replaced as desired. For example, a 6-inch drawer
may be replaced by a 2-inch and a 4-inch drawer, or
three 2-inch drawers.
• First remove the drawer (Refer to Operation A).
• Lift and hold the spring retainer, and push the slide to-
ward the rear of the unit. The slide may now be removed.
Spring Retainer
slide installation -
• Place the slide in the appropriate position in the unit and
pull toward the front of the unit until the spring retainer
snaps into position and secures the slide.
• For smooth operation, make sure that the drawers are
matched with their original slides.
troubleshootiNG
locK system
problem
cause
The unit unlocks
One or more
but the drawers
of the drawers
still will not open.
are holding the
lockbars from
releasing.
The cover on the
chest is holding
the lockbars from
releasing.
The release
cables are not
working.
The unit is leaning
too far forward.
The unit locks but
One or more of
some drawers still
the drawers are
are not locked.
not compeletly
closed.
solution
Completely close
all the drawers and
the lockbars will
release to open the
drawers.
Apply a downward-
pressure to the
top of the cover
to let the lockbars
release.
in an UNLOCKEd
position and pull
the lock lever sev-
eral times.
Position the unit on
a level area.
Unlock the unit.
Close all drawers
completely. Relock
unit.
Publicidad
Tabla de contenido
Solución de problemas
