Operating Of The Remote Controller; Automatic Operation - Daitsu CS259-R Manual De Funcionamiento

Operating of the Remote Controller

Install / Replace Batteries
The Remote Controller uses two alkaline dry batteries (R03/Ir03X2).
1. To install batteries, slide back the cover of the battery compartment and install the batteries according to the directions (+and -)
shown on the Remote Controller.
2. To replace the old batteries , use the same method as mentioned above.
1. When replacing batteries, do not use old batteries or a different type battery. This may cause the remote controller to mal-
function.
2. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery leakage may damage the
remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission Indicator light fails to appear.

Automatic Operation

When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the display panel of the indoor
unit starts flashing.
1. Use the MODE select button to select AUTO.
2. Push the TEMP button to set the desired room temperature. O The most comfortable temperature settings are between 21ºC/70ºF
to 28ºC/82ºF.
3. Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the display panel of the indoor unit lights. The ope-
rating mode of AUTO FAN SPEED is automatically set and there are no indicators shown on the display panel of the remote contro-
ller.
4. Push the ON/OFF button again to stop the unit operation.
Note: 1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN, HEAT and DRY by sensing the diffe-
rence between the actual ambient room temperature and the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually.
COOL , HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY, HEAT (HEAT PUMP units only),
or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature. When in COOLING mode, the most comfortable settings are 21ºC/70ºF
or above. When in HEATING mode, the most comfortable settings are 28ºC/82ºF or below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to operate per your settings. Push the ON/OFF
button again to stop this unit operation.
Note: The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps 1, 3 and 4 may be perfor-
med.
14
OPERATION