Esoteric G-02 Manual Del Usuario página 9

A
Reference frequency input connector [EXT IN]
To use an external reference signal generator (10 MHz output) for
the reference frequency, connect the output connector of the
reference signal generator to this EXT IN connector using stan-
dard BNC coaxial cables (50 Ω impedance).
0 If the output level of the external oscillator is outside the
allowable input range of this unit, it cannot be used. Refer to
the oscillator manual for information on the output level and
accuracy of the oscillator.
B
CLOCK OUT connectors
These connectors output the clock signal.
Connect these CLOCK OUT connectors to the clock/word sync
inputs of CD players, D/A converters and other digital equipment
using standard BNC coaxial cables (75 Ω impedance).
0 Use the A, B and C buttons on the front panel to change their
frequencies (see page 10).
0 Use the frequency mode setting (FREQ) to set the clock refer-
ence frequency (see page 14).
C
Ground connector [SIGNAL GND]
Audio quality might be improved by making ground connections
with connected devices such as digital equipment and amplifiers.
0 This is NOT an electrical safety ground.
D
AC power inlet
Connect the included power cord to this inlet. After completing
all other connections, plug the power plug into the AC power
outlet.
0 This unit uses a 3-pin power cord socket, but the grounding
pin does not connect to the chassis of the unit.
V Use only the supplied Esoteric power cord.
Use of other power cords could result in fire or
electric shock.
Unplug the power cord from the outlet when
you are not planning to use the unit for an
extended period of time.
At Esoteric, we use Esoteric MEXCEL stressfree cables for
reference.
For detailed information, access the following website.
http://www.esoteric.jp/products/esoteric/accessory/indexe.html
9