Publicidad
Idiomas disponibles
Idiomas disponibles
OIL EXCHANGE CYCLE
1. Leave the Black Hose (return) and the Red Hose (pressure) connected as described in the
previous steps, but disconnect the hose to the TOE New Oil Input Hose Connector.
2. Review the vehicle manufacturer's maintenance manual for the correct type and amount of
transmission fluid oil.
3. Remove the Oil Fill Cap on the top of the TOE and pour in the correct amount of new transmission
fluid oil. View the amount of fluid filling the TOE New Oil Tank Gauge.
4. Turn the (left) fuel Pressure Recycle Control knob to the Pressure position.
5. Turn the (right) Filling-Recycle Reverse Control knob to the Recycle position.
6. Turn on the power switch of the TOE begin the Oil Exchange. The pump pressure will force the
new oil into the transmission, start the engine while View the new oil flow in the new oil window.
During this process, View the new and used oil flow rate. They should flow at equal rates. If used oil
flow fast than new oil, please adjust the ball valve fixed on the oil black return line to make them have
the same flow rate.
7. During the oil exchange process, switch gears in sequential order, starting with first gear. Keep in
each gear for 10 seconds.
8. During this process view the oil flow through the TOE New and Used Oil View tubes. When the
color of the oil is the same in both tubes, turn off the engine and power switch of the TOE, the
process is complete.
9. Reconnect the vehicle oil output (return) line from the transmission to the input of the transmission
radiator. Securely tighten clamps.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
