Installation Instructions; Unpacking And Inspection - GE GXOF18K Manual Del Usuario

Installation instructions.

Unpacking and Inspection

Be sure to check the entire softener for any
shipping damage or parts loss. Also note
damage to the shipping cartons. Contact the
transportation company for all damage and
loss claims. The manufacturer is not
responsible for damages in transit.
Important Installation Recommendations
Read entire manual. Failure to follow all guidelines and rules could cause personal injury or
property damage.
■
Before you begin installation, read these
Installation Instructions completely. Then,
obtain all the materials and tools you will
need to make the installation. Failure to
properly install the softener voids the
warranty.
■
Check local codes. The installation must
conform to them.
■
Consult with your licend local plumber, if
you have questions on the Plumbing Code
■
Use only lead-free solder and flux for all
sweat-solder connections, as required by
state and federal codes.
■
Connect the softener to the main water
supply pipe before or ahead of the water
heater. DO NOT RUN HOT WATER THROUGH
THE SOFTENER. Temperature of water
passing through the softener must be
less than 49°C.
■
Use care when handling the softener.
Do not turn upside down, drop, drag
or set on sharp protrusions.
All manuals and user guides at all-guides.com
CAUTION:
Certain plumbing skills are needed for installation. If you are unsure about
any part of the installation of this product, consult a professional plumber.
Small parts needed to install the softener are
packaged either in a bag or on a cardboard
sheet. To avoid loss of the small parts, keep
them packaged until you are ready to use them.
Be sure not to discard components hidden in
packaging.
■
Maximum allowable inlet water pressure is
8.6 Bar. If daytime pressure is over 5.5 Bar,
nighttime pressure may exceed the
maximum. Use a pressure reducing valve
if necessary. (Adding a pressure reducing
valve may reduce the flow.)
■
The softener works on 24 volt-50 Hz
electrical power only. Be sure to use the
included transformer. Be sure the electric
outlet and transformer are in an inside
location to protect from moisture.
■
See Where to Install the Softener section for
more details.
WARNING:
Do not use with water
that is microbiologically unsafe or of
unknown quality without adequate
disinfection before or after the system.
The water should be tested periodically
to verify that the system is performing
satisfactorily.
■
Small parts remaining after the installation
could be a choke hazard. Discard safely.
3