Indoor Unit Installation Drawings - McQuay K Serie Manual De Instalación

01_EN_3P257187-1A.fm Page 4 Thursday, November 12, 2009 12:01 PM

Indoor Unit Installation Drawings

A Mounting plate
B Mounting plate
fixing screw
(M4 × 25L)
Front panel
50mm or more from walls
(on both sides)
Air filters
C Titanium apatite photocatalytic
air-purifying filter (2)
Titanium apatite
photocatalytic
air-purifying filter
Air filter
Filter frame
Tab
4
All manuals and user guides at all-guides.com
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
30mm or more from ceiling
Screws
(M4 × 16L)
Service lid
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
Front grille
Cut thermal insulation
pipe to an appropriate
Caulk
length and wrap it with
pipe hole
tape, making sure that no
gap
gap is left in the insulation
with putty.
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the
remote controller
D
holder to the wall,
Wireless remote
make sure that
controller
control signals are
properly received by
indoor unit.
E
Remote
controller holder
F Fixing screw for remote
controller holder
(M3 × 20L)
■English