Panasonic CQ-RG153U Manual De Instrucciones página 12

E Installation Guide
N
G
L
I
Cautions:
S
• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
H
• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
16
fingers.
First complete the electrical connections, and
then check them for correctness.(a page 25)
The included Mounting Collar
q is designed specially for this
unit. Do not use it to attach any
other model.
y Power Connector
Mounting Springs (C)
Engage the both sides
Mounting Springs (C)
in the mounting holes
of the Mounting Collar
q firmly.
Mounting Spring
e
(a) Using the rear support strap
Fire wall of car
rTapping screw 3 mmø
(5 mmø×16 mm)
wHex. nut
(5 mmø)
e Rear support strap
t Mounting bolt (5 mmø)
q Mounting collar
22
CQ-RG153U
(Continued)
1
Insert Mounting Collar q into the
dashboard, and bend the mounting
tabs out with a screwdriver.
The tabs to be bent vary depending on
the car. To securely install the unit, fully
bend a number of the tabs so that there
is no rattling.
Example:
q Mounting
Collar
Mounting Holes
t Mounting Bolt
Establish the rear connection of the unit.
2
After fixing Mounting Bolt t and Power Connector y,
fix the rear of the unit to the car body by either method
(a) or (b) shown below.
3
Insert Trim Plate i.
After installation re-
Mounting
4
Hole
connect the negative
(–) battery terminal.
(b) Using the rubber cushion (option)
Rear support bracket
Rubber cushion (option)
(provided on the car)
t Mounting bolt
q Mounting collar
To Remove the Unit
Switch off the power of the unit.
1 Remove the removable face plate.
q Press [
Tab
2 Remove the Trim Plate i with a screwdriver.
q Insert the Dismounting Plates u along the
3
w Pull out the unit while pushing the plates
4
Remove the unit pulling with both hands.
(5 mmø)
]. (release button). The
removable face plate will be released.
Contact
Release button
grooves on both sides of the main unit
until "click" is heard.
further inside.
Insert the tab
Insert the tab
end in the
end in the
outer groove.
outer groove.
"Click"
w
Push q
i Trim Plate
Screwdriver
q
w
q
Insert
u Dismounting Plate
w
Pull out
CQ-RG153U
23