Charging Indicator - Walmart Hyper Touch HT19-401-003-15 Manual Del Usuario

For battery charger
NOTE: The accessories of battery charger ( HT19-401-003-14 / HT19-401-003-13 ) and battery pack (ABP118T / HT19-401-003-
17 ) illustrated or described are not included in HT19-401-003-15 delivery.
(1) For charger ACG318W1U
CHARGING PROCEDURES (SEE FIG. A3)
Connect the battery charger to the power supply and the indicator light should turn to green. Then, slide the charger base on
the battery pack to make connections and the indicator light will turn red to show that the charging has started. It will remain
red until the battery is fully charged. A discharged battery at normal ambient temperature will take approximately 1.5 hours to
reach a full charge. When charging is completed, unplug the charger and remove the battery pack.
NOTE: green = power on;
red = charging.
(2) For charger HT19-401-003-14
IMPORTANT NOTES FOR CHARGING BATTERY
The battery in your new tool is not charged when it leaves the plant. Therefore it must be full charged before using the first
time.
NOTE: If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to cool
first to ambient temperature and then recharging can be started.
To prevent damage to the Battery Pack, when charge runs out, please charge the battery to reach full or no less than half
charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. A4)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger and remove the
battery pack.
WARNING: When battery charge runs out after continuously use or exposure to direct sunlight or heat, allow time
for the tool to cool down before re-charging to achieve the full charge.

CHARGING INDICATOR

Red on
Green on
(3) For charger HT19-401-003-13
IMPORTANT NOTES FOR CHARGING BATTERY
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is switched off by means of a
protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may become too hot to permit charging. Allow time for the battery
to cool down before recharging.
When the battery pack is charged for the first time and after prolonged storage, the battery pack will accept a 100% charge
after several charge and discharge cycles.
CHARGING PROCEDURE (SEE FIG. A5)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger and remove the
battery pack.
WARNING: When battery charge runs out after continuously use or exposure to direct sunlight or heat, allow time for the
tool to cool down before re-charging to achieve the full charge.
CHARGING INDICATOR
Light
Red on
Green on
All manuals and user guides at all-guides.com
Light
ON/OFF flash
Fully Charged
Fully Charged
9
Status
Charging
Status
Charging