Utilization And Functioning; Installation - Kunft KQH-2702 Manual De Instrucciones

2. utIlIzatIoN aND

2.1. Installation

1. unpack carefully. Make sure to discard of all packaging thoughtfully
and to keep the mounting screw kit.
2. The wall mounting height of the heater shall be 180cm. as shown
in the following figure, drill two holes on the wall. Diameter and
depth of the drilling hole are respectively 0.8cm and 3.5cm. The
gap between the two drilling holes is 8cm. The distance between
the drilling hole and side wall shall be 20cm or longer.
3. as shown in the following picture, insert the plastic bulged plug
into the drilling hole. fix the bracket screws into the wall of the
expansion internal rotation.
4. finally tighten the junction
box lid screws up and fix.
The maximum elevation
angle is 55 degrees.
Aqueced-Quartz-KQH-2702-Manual-2.indd 8
fuNctIoNING
8
16/06/20 18:10