Troubleshooting - Polar CC611 Manual De Instrucciones

UK

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
The appliance is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance Too much ice on the condenser
turns on, but the
Condenser blocked with dust
temperature is too
Doors are not shut properly
high/ low
Appliance is located near a heat
source, in the direct sunlight or
air flow to the condenser is being
interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
Factory default parameters adjusted Call POLAR or qualified technician
The appliance is The appliance is not properly
leaking water levelled
The appliance is Loose screw/nut
unusually loud
The appliance has not been installed
in a level or stable position
The display lamp Lamp needs replacing
does not illuminate
Light not turned on
Door does not shut Dirt/obstacle in runners
6
CC611-CC666_ML_A5_v6_20180125.indb 6
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
Defrost the appliance
Call POLAR or qualified technician
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Check and tighten all nuts and screws
Check installation position and change if
necessary
Call POLAR or qualified technician
Ensure Light button has been pressed
properly
Clean runners
2018/1/25 17:31