Initial Start-Up; Attaching Sanding Sheet; Attaching /Removing / Emptying Dust Collection Box - Parkside PSS 270 C3 Instrucciones De Montaje

GB IE

Initial start-up

Attaching sanding sheet

Clean the sanding plate before at-
taching a sanding sheet.
Remove the mains plug first.
Use only appropriate sanding sheet
sizes. Sanding sheets that protrude
laterally beyond the sanding plate
can cause injuries and can cause
the sanding sheets to block or tear.
The sanding plate (7) is fitted with Velcro for
rapid attachment of the sanding sheet (9).
Sanding sheet with Velcro:
1. Ensure that the sanding sheet (9) lies flush.
2. Press the sanding sheet (9) evenly onto
the sanding plate (7).
Ensure that the holes are placed direct-
ly above the extraction openings of the
sanding plate (7).
Sanding sheet without Velcro:
1. Release the two clamping levers (6).
2. Slide the sanding sheet under one of
the clamps (5).
3. Clamp the sanding sheet by locking the
clamping lever (6).
The sanding sheet must lie evenly and
tightly on the sanding plate (7).
4. Clamp the other end of the sanding
sheet in the same way.
22
Attaching /removing /
emptying dust collection
box
Attaching the dust collection box:
1. Before connecting, ensure that the dust
collection box (4) is firmly closed.
2. You must keep the dust collection box
(4) slightly slanted when pushing it
on. Slide the dust collection box (4) all
the way onto the connection for dust
extraction (12). The nose of the dust
collection box (4) must be inserted into
the groove (13) of the connector (12).
3. Then tighten the dust collection box (4)
clockwise to lock.
Removing the dust collection box:
4. Grasp the dust collection box (4) by
the black section.
Unlock the dust collection box (4) coun-
terclockwise and pull the dust collec-
tion box (4) off.
Emptying the dust collection box:
5. Open the dust collection box (4) by
slightly squeezing it on the transparent
part and pulling the two parts apart.
The dust box can be opened more ea-
sily by simultaneously pressing together
the black part of the dust collection
box from above and below.
Please note the arrows in Fig.
the direction of pressure.
6. Remove the filter insert (11) and empty it.
7. Re-insert the filter insert (11) and close
the dust collection box (4).
Empty the dust collection box regu-
larly to ensure optimal suction.
for