Belkin OmniView PRO Manual Del Usuario página 17

All manuals and user guides at all-guides.com
F1D116_OSD_AM_man.qxd 4/20/00 4:07 PM
Usage
SCAN TIME:
Amount of time the OmniView
on one port before switching to the next
port when in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection.
Note: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are
set on the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all of the active BANKs (if
there are slave units present) and then puts the unit into AutoScan mode. If the
unit is a single MASTER unit, pressing the button immediately invokes AutoScan
mode. This is evident by a long BEEP, followed by two short beeps.
Page 15
(continued)
SCAN TIME: SCAN TIME:
™ PRO stays
I I
7sec 7sec
DISPLAY TIME: DISPLAY TIME:
I 7sec I 7sec
[↕]: SELECT [↕]: SELECT
(INS): RENAME (INS): RENAME
(Enter):COMPLETE (Enter):COMPLETE
(Esc): (Esc):
15
I 15sec I 15sec I 30sec I 30sec I 60sec I 60sec
I 15sec I 15sec I I I 60sec I 60sec
30sec 30sec
Exit Exit
En