Beat Sync-Function; Faderstart - Omnitronic DJS-1200 Manual Del Usuario

Brake-effect:
The Brake-effect-effect equals the immediate stop/brake and starting of the track of the turntable, if the
Start/Stop-button is pressed. The Brake-time (PT) modifies the braking and starting speed of the track and
can be adjusted between 10 and 9990 ms. The ideal value for the Brake-effect lies between 600 and 800
ms.
Reverse-function:
The unlimited reverse play can be activated via the Reverse-function. The playback-direction can be
changed as often as you like by pressing the Reverse-button. The Reverse-time (PT) modifies the playback-
speed and can be adjusted between -1000 and 1000 as pitch change from -100 % to +100 %.
Overview over the effect-parameters:
Effects
Adjustable value
Flanger 0 - 9990 ms
Pan 0 - 9990 ms
Echo 0 - 2000 ms
Filter
Auto Filter 0 - 9990 ms
Reverse -100 - 100 %
Brake 0 - 9990 ms

6.12 Beat Sync-function

You can either adjust the effect-time via the Parameter Time-control or more comfortably via the Presets of
the Beat Sync-function.
Example:
Press the Auto BPM-button during playback and wait until the display shows the current value.
Press the Echo-button. Adjust the Parameter Time-control and watch the Beat Sync-LEDs.
When the Echo-time corresponds to a whole note, the 1/1 LED is lit.
In this way, the Beat Sync-LEDs show the most common time adjustments.
Via the Beat Sync-buttons, you can quickly and easily select the desired tact.

6.13 Faderstart

With the DJS-1200, you have the possibility to start the CD-player directly from the mixer. Make sure that the
Faderstart-socket is connected with the respective socket on the mixer. Additionally, the Audio Out-sockets
have to be connected with the Line-input sockets of your mixer. Please note that the Faderstart-function only
works with the appropriate mixers. Insert the CD and select the desired track (Pause-mode). Start playback
from your mixer.
Please note that the Faderstart-function is a Cue-point Faderstart-function. This means that the CD-player
starts playback after activating the respective channel of the mixer and goes into Pause-mode and returns to
the Cue-point after activating the channel again.
Prerequisites for the Faderstart-operation:
The mixer has to be connected via a 3.5 mm mono jack with the CD-player. For starting the playback, the
jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the playback,
the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.
Relay-function
In the Relay-operation, the device automatically switches to the other player after every track. In this way,
you have the possibility to enlarge the music program by using several CDs.
Possibility 1:
Connect the Faderstart-sockets of the two CD-players with one another. Choose Single or Continuous via
the SGL/CTN-button. The playback switches from one player to the other.
All manuals and user guides at all-guides.com
Parameter PT
Default value
1000 ms
450 ms
350 ms
6000 ms
0 ms
35/69
Parameter PR
Adjustable value Default value
0 - 255 179
0 - 255 128
0 - 255 0
0 - 255 0
0 - 9990 ms 0 ms
10602296X10NXS_V_1_0.DOC