Publicidad
Idiomas disponibles
Idiomas disponibles
Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose
and threaded base and tighten the collar nut
by hand. If there is not enough space, please
use only the slide washer and the metall without
the plastic washer.
4. Tighten screws.
5. Connect the connecting hose to the angle valves;
cold right - hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 17.
No adjustment is necessary when using a continuous
flow water heater.
English
Spare parts (see page 3 + 4)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10 seal
11 sealing set
max. 1 MPa
1,6 MPa
max. 80° C
65° C
11 l/min 0,3 MPa
lever head
flange
nut
cartridge cpl.
aerator cpl.
fixation cpl.
connection hose 600 mm 3/8" 96510000
connection hose 600 mm
ELASTOP stop unit
33891000
96338000
96391000
94194000
92730000
13913000
95049000
14099000
94849000
95008000
96529000
7
Publicidad
