Cleaning The Pool - Steinbach 061205 Manual De Instrucciones

Cleaning the pool

Observe the following before cleaning your pool:
- Remove any cover or foil from the pool.
- Remove obstacles (such as a ladder) from the pool.
- Switch off the filter system at least one hour before the start of cleaning so that particles in the
water can settle on the floor.
Proceed as follows to clean your pool:
1. Insert the filter unit.
2. Place the device in the pool and switch it on.
Inserting the filter unit
1. Make sure that the dirt slots
before inserting the filter unit.
2. Insert the filter unit
2
in the correct position with the guide lugs
pointing upwards.
3. Place the top part
1
the bottom part . In doing so, pay attention
3
to the guide lugs on the marked locking points.
4. Close all clips .
12
The filter unit is inserted.
Placing the device in the pool and starting cleaning
8
1. Hold the device by the handle
the air has escaped.
are closed
11
into the bottom part
3
in the correct position on
and lower it slowly into the water (tipped slightly forward) until all
8
6
2
11
3
7
1
3
12
9
13
25