Sterilising, Heating Or Thawing - ItsImagical ALFA babicare BBRobot Manual De Instrucciones

• Plug in the cord into the wall power socket and turn on the On/Off switch. If the assembly has
been properly locked, the 3 pictograms (steam, crush, vacuum packaging) will light up in green.
Otherwise, for safety reasons, the robot will not work until it has been fi rmly fi xed into place once
again).
• So as to function, the symbol BLADES must be pressed down throughout the crushing pro-
cess. The blades indicator will remain light up in blue throughout the entire process). The robot
will automatically stop after 10 sec. (1 crushing cycle) and the BLADES indicator, together with
the other indicators (Steam and Vacuum Packaging) will once again light up in green, indicating
that the robot can be reused.
Press again if you want to continue beating (max. 2 consecutive cycles), after 2 cycles, the LED
display will show a red light. After 2 cycles the motor will stop for 1 min after which it can be star-
ted again. If the blades button is pressed again when in operation, the process will be cancelled
automatically.
• Open the lid by using the handle, then remove the holding grille and pour the contents into
another receptacle for consuming or storing (with the help of a wooden or plastic spatula so as
not to damage the blades).
It is recommended to always unplug the appliance before cleaning it or
when it is not being used

Sterilising, heating or thawing

Specifi c information to read before using the robot as
a sterilising/heating/thawing appliance:
• Do not use the BBRobot to heat or sterilise without
the necessary amount of water in the pail.
• The blades must be fi xed in place during
sterilisation / heating / thawing.
• The basket must be used for heating, thawing or sterilising,
106
otherwise, it will damage the robot.
• Do not heat foods for longer than the recommended time, as it could favour the growth of
microbes in the food
• Suitable for all types of baby bottles (low, high, wide or thick, glass, plastic, rubber or silicone
teats and dummies).
• Baby bottles and jars must always be open (they must be of glass, polycarbonate or polypro-
pylene).
• Do not heat full bottles.
How to use:
• Fill the preparation jug or any other jug with a measuring beaker with the amount of water
required (see water dose table) and pour that water into the pail (the water always at room tem-
perature).
• Place the preparation jug and the cooking basket in case of:
• Heating/Thawing Foods: Foods to be heated must be always placed in a jar without its
lid (the BBRobot jug or any other glass, polypropylene or polycarbonate jar). The jar will be
placed inside the basket.
(Should you wish to heat/thaw two jars, place the second jar over the support grate) (Add
the jug extension whenever necessary)
• Sterilising baby bottles or dummies: The products to be sterilised must be placed inside
the basket. Always face down.
• Whenever needed, the support grate and jug extension may be added, as it will provide an
increased capacity.
• Cover the basket with the jug extension and the lid.
• Plug in the cord into the wall power socket and turn on the On/Off switch. If the assembly has
been properly locked, the 3 pictograms (steam, crush, vacuum packaging) will light up in green.
Otherwise, for safety reasons, the robot will not work until it has been fi xed fi rmly into place once
again).
• Pressing the steam symbol. The process will automatically start after 3 sec after being selected
(the steam indicator will light up in blue).
• When the process has fi nished, the steam indicator will change to fl ashing red light, indicating
that the robot is hot (2 mins).
• When the steam function has fi nished, the red steam indicator turns off, 2 consecutive beeps
will be heard indicating that it has fi nished. The 3 pictograms (steam, crush, vacuum packaging)
EN
107