For Your Safety - Festo 8024881 Descripción Resumida

For your safety

General
 Trainees must only work on the Robotino
 Observe the data in the data sheets for the individual components, in particular all notes on safety!
 The Robotino
®
may only be packed in the fully switched-off state.
Electrics
 Electrical connections are to be wired up or disconnected only when power is disconnected!
 Use only low voltages of up to 24 V DC.
 Earth the Robotino
®
housing ("command bridge") before opening it. Remove the housing without
touching any electrical components  watch out for electrostatic discharge.
 Always position the command bridge vertically so as not to damage the raised pin contact.
 Modifications to the wiring or conversions in the command bridge are carried out at your own risk and
nullify the warranty. Only use genuine spare parts.
 Switch off Robotino ®
before changing the memory card (CF card).
 Danger of short circuiting!
If no Access Point is connected, insert the Access Point's power supply plug into the socket provided for
this purpose on the end of the cable, because danger of short circuiting otherwise exists.
 Always charge batteries in series (12 V + 12 V), disconnect charger from Robotino
charger is disconnected from the mains but left connected to Robotino
batteries.
Mechanics
 Move the Robotino
®
only by carefully seizing it by its handles.
 Securely mount all components on the chassis.
 No manual intervention unless the Robotino
 Never touch the wheels on Robotino
turning. To increase the resistance at the wheel, press Robotino
PID controller).
 Robotino
®
features a precision laser-cut and laser-welded stainless steel design; Watch out for sharp
edges when working with it (cable routing, mechanical assembly/disassembly).
© Festo Didactic 8028835
®
under the supervision of an instructor.
®
is at rest.
®
! Depending on the program, the wheels could suddenly start
®
after charging. If the
®
, it can discharge/damage the
®
into the floor (e.g. for exercises on the
7