Brightness Adjustment - Member's Mark SF127B-33AI Manual Del Usuario

Touch the heater button
the heater up button
When the heating function turns on, touch and hold heater button
The temperature setting range is between 62°F - 82°F - ON (17°C - 27°C - ON). NOTE: The heater default temperature is set to 72
degrees Fahrenheit. If your ambient room temperature is above 72 degrees, then your heater will automatically shut off after few
minutes. Adjust your heater thermostat to a higher temperature in order to keep your heater ON above 72 degrees.
Timer Function.
You activate the timer by touching the button multiple times to get the amount of time you want the fireplace/heater to run. The
timer button operates both the flames and the heater function. If the heater is operating when the timer is set, then the heater is
on the timer. If the flames are operating, then the timer will control the flames. If both the heater and flames are operating with
the timer is set, then the timer controls both the flames and the heater. Touching the button in sequence will set the timer for a
set interval. This interval period is shown in the display segment, and the red LED light turns on to show that the timer function
is engaged. The set intervals are displayed in this table:
BUTTON PRESS
The timer starts after you select your preferred interval and release the button; note that the display and red light will turn off
after a few seconds. There is no clock function for turning the heater or flames on or off at a specific time.

Brightness Adjustment

There are six settings for the brightness. Touching the brightness button in sequence will set the brightness for different level.
It will deactivate the flame color and speed adjustment function if you set the brightness to "H0".
Flame Color Adjustment
There are six settings for the flame color. Touching the flames button in sequence will set the flames for different color.
TM
To turn on Bluetooth link, gently touch and hold the flame button for 5 seconds until the front LED lights show "bt". The
display unit flashes 30 seconds, indicating it is in searching and pairing mode. The LED lights stop flashing and indicating once
your Whalen Fireplace Bluetooth
NOTE: When the unit is turned off that LOGS completely die out for 3 seconds.
6
OPERATION (CONTINUED)
Heater Control.
to turn the heater on or off. Touch the heater down button
to turn up the heat.
TIMER INTERVAL
st
1 press 30 Minute Interval
nd
2 press
rd
3 press
th
4 press
th
5 press
th
6 press
th
7 press
th
8 press
TM
remote app paired with the fireplace.
Need Assistance? Visit us at: samsclub.com/membersmarkhelp
for 5 seconds to enter temperature converting mode.
1 hour
2 hour
3 hour
4 hour
5 hour
6 hour
OFF
to lower the heat and touch
DISPLAY VALUE
30
1h
2h
3h
4h
5h
6h
OF