Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
en
ENGLISH
Machines with Paddle Switch
(with dead man function):
Switching the angle grinder ON just for a
moment:
Switching on: Press in the lock (5) and then press
the trigger switch (6). Let go of the lock (5).
Switching off: Release the trigger switch (6).
Continuous operation (depends on machine
features):
Switching on: Press in the lock (5) and hold in place.
Press and hold the trigger switch (6). The
machine is now switched on. Now press in
the lock (5) a second time to lock the trigger
switch (6) in position (continuous operation).
Switching off: Press and release the trigger switch
(6).
7.2
Working instructions
Grinding:
Press down the machine evenly on the surface and
move back and forth so that the surface of the
workpiece does not become too hot.
Roughing: position the machine at an angle of
30° - 40° for the best working results.
Separating:
Always work against the run of the disc
(see illustration). Otherwise there is
the danger of the machine kicking
back from the cut out of control. Guide
the machine evenly at a speed
suitable for the material being processed. Do not tilt,
apply excessive force or sway from side to side.
Sanding:
Press down the machine evenly on the surface and
move back and forth so that the surface of the
workpiece does not become too hot.
Wire brushing:
Press down the machine evenly.
8. Cleaning
Motor cleaning: blow compressed air through the
rear ventilation slots of the machine regularly,
frequently and thoroughly. Here, the machine must
be held firmly.
9. Troubleshooting
(WE 1450)
Restart protection: The machine does not start.
The restart protection is active. If the mains plug is
inserted with the machine switched on, or if the
current supply is restored following an interruption,
10
5
6
the machine does not start up. Switch the machine
off and on again.
10. Accessories
Use only genuine Metabo accessories. See page 4.
Use only accessories which fulfil the requirements
and specifications listed in these operating instruc-
tions.
A Safety guard for cut-off grinding
Designed for work with cut-off wheels, diamond
cut-off wheels.
Install as described under "Safety guard for
grinding" (chapter 5.2).
B Hand guard for sanding and wire brushing
operations
Designed for work with support plates, sanding
pads, wire brushes.
Install hand guard under the additional side-
mounted handle.
C Adjusting nut (9)
For a complete range of accessories, see
www.metabo.com or the accessories catalogue.
11. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
D
=max. diameter of accessory
max
t
= max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (9)
t
= max. permitted thickness
max,3
of accessory
M
= Spindle thread
l
= Length of the grinding spindle
n
= Rated speed (maximum speed)
I
= Current at 120 V
120 V
P
= Nominal power input
1
P
= Power output
2
m
= Weight without mains cable
Publicidad
Tabla de contenido
